I mostly agree with what Jim Stuart has said. I think that the
Carter/Edelbrock/Weber 4-barrel is a superior street and mild performance
carb. However for all out power a finely tuned Holley is better (OK, that
is just my opinion). Also I believe that a Holley 390 is too small for a
hot 4.6 L V8. The Holley 600 is a better choice for a hot 4.6 L. The
Holley 390 is a better choice for a 3.5 L & 215.
Oddly I have never had a gas leakage problem with a Holley 390. One of my
215's has had the same Holley 390 on it since 1977, and it has never leaked
(or been rebuilt). However I did have the Holley 600 in my boat (Ford 351
V8) start to leak. That scared me quite badly (leaking gas in a boat is not
good!). I replaced it with an Edelbrock/Weber 600 and I like it very much
in that application.
Regards,
Jim B.
----- Original Message -----
From: "Jim Stuart" <jimbb88@erols.com>
To: "Susan and John Roper" <vscjohn@huntnet.net>; <TR8@Mercury.1cs.mit.edu>;
<mgb-v8@autox.team.net>
Sent: Tuesday, August 14, 2001 8:11 PM
Subject: RE: Edelbrock: Carter)carb
> John-
>
> That is the inherent ability of the Carter/Edelbrock design that makes it
> superior to the Holley for normal people. The Holley may eventually
> outperform the C/E carbs, but only with many modifications, & it will
still
> leak gas.
>
> Jim Stuart
>
> -----Original Message-----
> From: owner-mgb-v8@autox.team.net [mailto:owner-mgb-v8@autox.team.net]On
> Behalf Of Susan and John Roper
> Sent: Tuesday, August 14, 2001 9:11 PM
> To: TR8@Mercury.1cs.mit.edu; mgb-v8@autox.team.net
> Subject: Edelbrock(ne: Carter)carb
>
>
> Thought I would share recent experience re: the Holley 390 vs. Edelbrock
> discussion. I have recently completed a built 4.6 for my TR8(high
> compression, Woody cam, big valve worked heads, light flywheel,
> balanced, Huffaker headers, edelbrock performer, Mallory unilite).
> Cranked the new motor on the 390 as I had experience with it and knew it
> was functional. After rejetting it ran reasonably well but my sense was
> that the engine did not have the punch that I had expected. Just
> completed swapping an Edelbrock 600cfm. The new motor came alive, now
> runs like expected. Would run right straight up a pole if asked to.
> Interesting that it required no recalibration. It idles well, pulls
> well from low revs, is smooth at part throttle, and storms when
> punched. John
///
/// buick-rover-v8@autox.team.net mailing list
///
|