Hi John. Couldn't sell the front cover to you if I wanted too... I didn't
get it in the deal. Just the block, crank and rods with pistons.
Greg
-----Original Message-----
From: Susan and John Roper [mailto:vscjohn@huntnet.net]
Sent: Tuesday, August 29, 2000 10:30 AM
To: Gregory Williams
Cc: 'buick-rover-v8@autox.team.net'
Subject: Re: Rover blocks
Greg, Its an interim block, probably a '94. Takes the small journal crank.
The
front cover off of that block is especially interesting, in that it has the
new
style oil pump that is driven off the crank, but will take a distributor.
Are
you interested in selling? John
Gregory Williams wrote:
> Since we're on the subject of blocks, I thought I might launch a query. I
> picked up a 3.9 block in a deal last year. The gent that sold it to me
said
> it was a 4.0. I inspected it pretty closely and found that it had the
> beefed up webbing of the 4.0/4.6 and the thick main caps as well. It also
> had bosses along the side of the block for crossbolts but they were'nt
> drilled and tapped for them. However, it had 5 bolt holes around each
> cylinder, 3.9 style rods and 2.3" mains. What is this? A 3.9 1/2?
>
> Greg
>
> -----Original Message-----
> From: Ric Smith [mailto:rsmith@coppercom.com]
> Sent: Monday, August 28, 2000 8:26 PM
> To: 'Jan Ben'
> Cc: 'buick-rover-v8@autox.team.net'
> Subject: Isky reverse rotation cams
>
> Jan, are you spinning the engine backwards like I am? Obviously reverse
> rotation cams don't help a normal motor. Isky does currently stock normal
> rotation cams for the 3.5 in about 4 obsolete grinds, mostly on 110
centers.
> I had them do a custom grind for me but it was too peaky and the
horsepower
> peak wasn't that good either so I advise conservative grinds for better
> torque. I'd check out RPI in UK for street cams for Rover trucks. Try
> www.rpiv8.com. It's good reading all over their site.
>
> I shopped for a 4.6 block for 3 years before I found a shop with just a
> block. They had dropped a nut down the intake and trashed one cyl liner.
I
> paid just under a grand for the block with one hole resleeved and main
caps.
> No crank, no top end, nothing else. I still need a windage tray for it
and
> don't want to pay dealer prices. Any suggestions? ric.
|