buick-rover-v8
[Top] [All Lists]

Re: Info needed: Thermostat Housing Problem

To: Pete Bronlund <peteb@clear.net.nz>
Subject: Re: Info needed: Thermostat Housing Problem
From: lmg@gomog.com
Date: Mon, 14 Aug 2000 04:52:24 -0400
Pete Bronlund wrote:
> 
> My Rover 3.5 engine uses an Edelbrock Performer inlet manifold. The
> curve of the bonnet (hood) means that with the standard Rover themostat
> housing (ex P6B) the hose is directed upward at such an angle that the
> bonnet can't be closed. Today i found a housing for a Ford 351(?),
> partcode# EOSE-8592-AA, which almost bolts on but without major surgery
> that won't happen. It would allow the radiator hose to lie in a curve
> round the distributor with heaps of room to close the boonet. I'm
> wondering if perhaps the housing used on an MG V8 is at all different to
> the P6B unit since the MG has a similar low bonnet line like my project.
> 
> At this stage though i might have to have my own one (or two) cast. Any
> info appreciated.

Could you send me a digital view of your thermostat and I will return
the favour. I have a strong feeling that the Morgan Plus 8 housing might
help.

Lorne

<Prev in Thread] Current Thread [Next in Thread>