I'm only an R and R mechanic, so maybe it is impossible, but if you have the
machine shop tools and skills, might it not be easier/quicker/less
"butchering" to make something that would allow you to mate the MG motor to
the Singer drive train?
-----Original Message-----
From: british-cars-bounces@autox.team.net
[mailto:british-cars-bounces@autox.team.net] On Behalf Of Mike Rambour
Sent: Tuesday, March 16, 2010 10:42 PM
To: british-cars@autox.team.net; british-cars-pre-war@autox.team.net
Subject: [British-cars] are these lists still alive ?
I have a question about my 1934 Singer, I have very serious concerns
about the motor and I am considering a temporary engine swap. The
Singer is a 6cylinder 1.5litre car, I have free access to a late 1960's
or extremely early 1970's MGB that is pretty much a running rust bucket
parts donor. I am going to assume that its a 1800cc motor but anyone
know the weight of the motor also motor and trans ?
The Singer wheel track is 4'4" front and rear and according to the
internet the MGB is 4.125 for the rear, I would have to put the Singer's
18" wire wheels on the MGB's rear axle. Would that track difference be
a issue on the handling of the car ? since its wire wheels I am not sure
I could put in spacers like you would on a steel rims.
My thinking is to butcher this extremely rare 1934 Singer and put in
the MGB drivetrain while I get the Singer motor redone, that will take
some serious cash, the block is cracked, I have to have pistons made,
babbitt bearings poured and its all going to be very expensive. I would
not want to do any permanent butchering of the Singer, anything and
everything I do would have to be reversable when I finish the proper
motor but it gets it on the road for now.
Both rear ends are leaf springs so I don't see a issue there, the
engine compartment is quite roomy for the 6 cylinder so the MG 4 should
fit very nicely (not measured anything yet), I could weld up motor
mounts that minimize the damage to the Singer or better yet do no
damage. The only "gotcha" I have at this time would be the clutch and
brake pedal assembly and mixing the MG rear brakes with the Singer front
brakes, I have to check on that as I don't even like the sound of it,
but I should be able to take the MG front axle back plates and put them
on the Singer, so I am back to just the pedal assembly without damaging
the Singer chassis.
I have all the cool toys to do this with, lathe, mill, welders, etc. I
just don't have the engine/drivetrain switching knowledge, never done
that YET but it does not look too hard. Well I have started it on
another car but its not finished yet.
mike
_______________________________________________
British-cars@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/british-cars/lherault@bu.edu
_______________________________________________
British-cars@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|