Speedi-Sleeve went on crankshaft OK.
When flywheel installed, it was pressing the sleeve off.
I believe that the flywheel to crankshaft opening needs to be enlarged,
to
accept the sleeve thickness.
Make sure that the cork gasket fully sits in the groove on the rear
main cap.
John Seim
Irvine, CA
On Nov 26, 2008, at 4:13 PM, Mike Duvall wrote:
> Has anyone successfully used the speedi-sleeve with the XPAG oil seal
> kit? It wouldn't fit my engine. After I got mine all back together,
> it leaks a little and I want to know if it actually can work. The
> directions for the speedy sleeve in the seal instructions contradict
> the addendum which tells you to put the sleeve on backwards.
>
> I had an engineer look it over and he had me grind off the excess
> edge of the sleeve to get enough clearance to not hit the Moss adapter.
>
> Moss is no help. Their tech support guy didn't even know what the
> speedi-sleeve was and I had to send him the part number so he knew
> what I was talking about.
>
>
> If I had to do it again, I would keep my $250 pull the pan and
> replace the cork rear gasket with some modern sealer. I think that
> is where the oil was coming from anyway.
>
> Mike
>
> ------------------------------------
>
> Yahoo! Groups Links
>
> <*> To visit your group on the web, go to:
> http://groups.yahoo.com/group/mg-tabc/
>
> <*> Your email settings:
> Individual Email | Traditional
>
> <*> To change settings online go to:
> http://groups.yahoo.com/group/mg-tabc/join
> (Yahoo! ID required)
>
> <*> To change settings via email:
> mailto:mg-tabc-digest@yahoogroups.com
> mailto:mg-tabc-fullfeatured@yahoogroups.com
>
> <*> To unsubscribe from this group, send an email to:
> mg-tabc-unsubscribe@yahoogroups.com
>
> <*> Your use of Yahoo! Groups is subject to:
> http://docs.yahoo.com/info/terms/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
British-cars@autox.team.net
http://autox.team.net/mailman/listinfo/british-cars
|