Don:
As Terry has pointed out, this is now commercially possible. I did
the same thing on my Standard Vanguard by using two flashers. This
way I was able to take current from the switch-on position which
activates the trafficator. By attaching a flasher unit to each of
the hot wires from the switch I was able to send flashing current to
the appropriate side of the car.It is quite easy to do, once you've
identified the correct output wires - which is not difficult,
especially if you have a wiring diagram. You could enclose the whole
thing in a box and mount in unobtrusively in the engine compartment.
My Vanguard had been equipped with add-on Lucas clear beehive lenses
in front, and a flasher circuit, when it came to North America as a
new vehicle. The rear lights remained the same. The installing
dealer had simply cut the wires to the trafficators so all I had to
do was reconnect them then add an additional flasher after separating
the circuit into right and left. Fortunately nothing else of the
original wiring had been tampered with.
John
>In a message dated 5/20/03 08:15:30 Pacific Daylight Time, don1@mailstart.com
>writes:
>
><< I have just wired up the semaphores on a '37 Bentley which are
> the turn signals. I want to add some "real" turn signals using
> the same contacts on the existing switch. Anyone have a circuit
> for such a thing?
> >>
>
>Don, I did this on my '37 MG SA Tickford. Restoration Supply in Reno, NV
>sells a relay box and a diagram that makes this easy. They have a web site
>but you'll have to call.
>Terry in Oakland
>
>/// british-cars@autox.team.net mailing list
>/// Send admin requests to majordomo@autox.team.net
>/// or try http://www.team.net/cgi-bin/majorcool
>/// Archives at http://www.team.net/archive
>/// Send list postings to british-cars@autox.team.net
/// british-cars@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|