On Thu, 26 Jan 1995, Stan Fickes wrote:
> Hi all-
> Anybody have some suggestions on the best way to remove Bondo from sheet
> metal? Some budding sculptor added a thick layer to the Sprite rear end,
Paint remover will soften it so it can be removed. If you are sure that
heat won't distort the metal too much, a propane torch will soften it
like old paint. Smelly, though, have a window open.
Ray Gibbons Dept. of Molecular Physiology & Biophysics
Univ. of Vermont College of Medicine, Burlington, VT
gibbons@northpole.med.uvm.edu (802) 656-8910
|