In message <01HK1PJW7A9U8Y4Z8M@admin.cc.williams.edu> you write:
>I cut out cardboard replicas of the instruments and guages, and wrote the name
>of the instrument on each. I then punched holes in each cutout to correspond
>with the location of each wire that is connected to the guage. As I
>disconnected the wires, I pushed the wire through the corresponding hole on
the
>cardboard. Presto! When I reassemble dash I don't need to refer to the wiring
>diagram. Very elegant and easy, IMHO. YMMV.
This is elegant and easy, and worked fine for you since you had installed the
wiring harness yourself. Sybil has 20 years of PO wiring bodges back there to
deal with (and one or two of my own, I confess) and I'm not sure ANYTHING is
where it's supposed to be!
|