Will Zehring writes:
>
>Fellow fiends:
>
>I am finishing up the wiring on the '63 B and have a question regarding the
>coil. In the Haynes manual it identifies the two plug connectors at the top
>of the coil as "sw" and "cb." When I look at the coil I see only a (+) and
>a (-). Keeping in mind that this is going to remain a (+) earth car, I
>suppose that the lead that goes from the coil to the plug on the body of the
>distributor is (-)? Yes/No?
>
>Will Zehring
>
>
No. "sw" = switch (i.e. ignition switch); "cb" = circuit breaker (i.e.
points). Since the points short to ground, the wire from the distributor
should go to the "+" terminal (anode) on a positive ground car.
I'm working from (suspect) memory, so netters feel free to correct.
regards,
bs
|