Scott W. Paisley 303-497-7691 wrote:
[...deleted tale of ring gear woe...]
> Now I'm going to find a shop to heat the starter ring and get this
> sucker secured. Anyone got tips on making sure this doesn't happen
> again? (superglue?, jbweld? :-)
*** I would use Loktite. After the flywheel comes back from the machine
shop, heat the whole thing gently with a propane torch. Then when its
good and warm, run a bead of loktite around where the gear and flywheel
meet. It should get sucked in by capillary action. The only question
left, is *what grade of loktite to use*? ``Studlock 270'' comes to
mind, I could have the number wrong.
- Jerry Kaidor
|