Howdy,
My Midget arrived from Portland this morning. I started out by giving it
a good cleaning and degreasing the engine. It was kind of an eyesore
when it first arrived because the paint was oxidized and stained. I took
Scotts advice and gave the Meguars a try. The difference is amazing!
Anyway, I removed the seats and carpet to check the floorpan. When I
looked at the car the floorpan seemed fairly solid. Upon removing the
carpet, I discovered that on both sides at the rear seat bolts closest to
the doors the floor has rusted a little thin. The floor pans are still
pretty solid. I weigh 200 pounds and can bounce up and down on the floor
without it doing anything. So should I just sand the floorpans down and
seal them? Is there a good rubberized coating that I can apply with a
brush to prevent further damage?
Thanks!
Curt Onstott
|