I'm just completing this, and ran into a few questions on (what I hope
is) final assembly...
First, where the heck do you get torque settings? The Bently manual is
darn sparse on these. The ones I need are:
1. Top spindle pivot bolt
Also:
* The bevel on the head of this did not fully engage the shock - is
this a
problem?
* I had a devil of a time getting this into the shock arm. I
basically ended up
removing the bolt holding the arm together, then pry like mad and
push - is
this normal?
* Is there any way to lubricate this - no zerk fitting?!
2. Lower spindle pivot bolt.
Also:
* Should there be a lock washer on this? Seems kind 'o silly with a
castle
nut...
Second, any major gotchas to check for? This is my first rebuild, and
I'm planning on taking it to a local shop (Phil, where does Brian work
again?) to have it checked over before auto-xing. Please respond
directly - I'm several weeks behind on my digests. And thanks in
advance for all assistance offered!
|