| To: | british-cars@autox.team.net |
|---|---|
| Subject: | MGB front wheel bearings. |
| From: | interf!atlas!jhoward@uunet.UU.NET (James Howard) |
| Date: | Tue, 6 Jul 93 10:59:03 EDT |
Both the Haynes and the Factory Workshop manuals say to put sufficient shims in the front wheel bearings to give an endfloat of 0.0xx inches. What is endfloat? Is it the amount of axial movement of the wheel? I can borrow a dial gauge to measure it, but I need to know what to measure. James 'trying to get this thing so it will pass inspection' Howard |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | rear wheel studs, Richard George x 7247 |
|---|---|
| Next by Date: | forwarded message from paulg, Scotty Paisley |
| Previous by Thread: | rear wheel studs, Richard George x 7247 |
| Next by Thread: | forwarded message from paulg, Scotty Paisley |
| Indexes: | [Date] [Thread] [Top] [All Lists] |