Don't know if this got through the first time:
I just spoke with the folks at Aplle Hydraulics. They moved again, the new
address is:
1610 Middle Rd.
Calverton, NY 11933
same # (800)882-7753
Spoke with them about rebuilding Z-S carbs. They manufacture a lot of the
parts no longer available like jets and needles, so they do a complete job on
them. Since I'm in CA, they'll install emmission needles to pass smog, but
send an extra set of earlier needles for better performance. BTW, the price of
$295 for a pair of carbs goes up to $375 in July. They also do
master/slave/wheel cylinder sleeving at $60/sleeve. One last note, I was able
to order a set of K&N filter assy's for the GT6 through Auto parts club for $25
each (lowest i found before was $34). I had to supply the part#, though, which
I got from K&N.
Mike G.
|