I've been having trouble removing my MGB '76 engine/transmition.
Maybe I'm going about it wrong. I've got two chains wrapped around
the engine, which are connected to a hydrolic lift. The four
bolts connecting the transmision are out, as are both
engine mounts. When I start to raise the engine, it goes up
about 4 inches, then something gets caught, near the back.
I suppose, at this point, I should pull the engine forward to free
up the transmition so it can be raised as well. But no go,
it won't move forward, no matter how hard I pull. I stoped
messing with it to get some advice before I break anything more!
Does this experience ring familiar with anyone out there?
What are the exact steps ?
Thanks,
dan@gordian.com
|