Don,
First question:
When you removed the head to your B and looked at the head gasket, was it
blown??
?#2 Did you run a compression check before pulling the head? Have you run one
recently??
?#3 Have you checked your timing? was it on??
?#4 When you had the head off, did you run a straight edge over the head &
block to check for warps??
Bonus test: Fill the radiator, leave the radiator cap off; start engine;
wait until engine comes up to operating temperature. When (if) the
thermostat opens, you will have a noticable water flow (If you do not
see the coolent flowing suspect the thermostat). Is there constant stream
of bubbles??? If yes you have a leak between at least one cyl & the cooling
system. While you are at it you might want to check the temp. of the coolent
when the thermostat opens & again about 5-10 minutes afterwards.
Please answer the above questions & I will consult my answer '8' ball for a
solution.
Take care,
TeriAnn
|