----- Original Message -----
From: "serge" <serge.ber@sympatico.ca>
To: "Greg Schroeder" <gschroeder@comcast.net>
Sent: Monday, July 13, 2009 6:49 PM
Subject: Re: [Bricklin] Air door leak
> im not sure of your setup check tank ..some have valve you can fill air at
> gas tank near buttom some let go sometime could be tank too...rusted out
> ..spray water and joy ...look for bubbles ...good luck serge
> ----- Original Message -----
> From: "Greg Schroeder" <gschroeder@comcast.net>
> To: <bricklin@autox.team.net>; <maycinc@cs.com>
> Sent: Monday, July 13, 2009 4:01 PM
> Subject: Re: [Bricklin] Air door leak
>
>
>> If you have any brass outside and vinyl inside compression fittings you
>> may
>> want to replace them with brass. I had one pop off a cylinder while it
>> was
>> up and the door slammed down. Could have been dangerous if someone was
>> trying to get in/out of the car. The vinyl fitting around the hose just
>> gave way. I would believe that these over time would leak also, but I
>> would
>> work through the leak first since you could cause more issues while
>> replacing all fittings.
>>
>> Greg 0036
>> _______________________________________________
>> Support Team.Net http://www.team.net/donate.html
>>
>> Bricklin@autox.team.net
>> http://autox.team.net/mailman/listinfo/bricklin
>>
>> You are subscribed as serge.ber@sympatico.ca
>>
>> http://www.team.net/archive
>>
>
>
>
>--------------------------------------------------------------------------------
>
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 8.5.375 / Virus Database: 270.13.12/2235 - Release Date: 07/13/09
> 05:56:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Bricklin@autox.team.net
http://autox.team.net/mailman/listinfo/bricklin
http://www.team.net/archive
|