OK, I almost have the engine rebuild and the 700r4 transmission installed. I
am just about 1/4 inch off of installing the motor mounts. I had to remove
them to get the transmission past the firewall and removing these and
installing them after the engine is installed it a real pain. It looks like I
am going to be about three inches short on the drive shaft as I expected from
comparing the Torque Command to the 700r4. What are my options to resolve
this issue?
Greg 0036
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Bricklin@autox.team.net
http://autox.team.net/mailman/listinfo/bricklin
http://www.team.net/archive
|