Re: Header Installation continued - Oil Dipstick shaft removal

["High Tech Coatings" <rick@hightechcoatings.com>]

Just leave it off, it was only there to help in the manufacturing process.
some manufacturers just use small port plates and don't connect them at all
to save on steel. Chevy guys for years cut the flange to help with warping
and seal.
 Rick R

On 10/12/06 8:32:43 AM, Greg Schroeder (gschroeder@comcast.net) wrote:
> Rick,
>
> Thanks.  Should I try to tack it back after installation or just leave
> it?
>
> Greg 0036
> ----- Original Message -----
> Fro