Bleeding the brakes -metering valve

["Alan Coleman" <colemaal@hotmail.com>]

I've replaced the calipers, the rear wheel cylinders and am installing a new 
master cylinder as well.  I've searched archives for info concerning the 
metering valve, but haven't found a whole lot.  What have people 
used/fabricated (besides vice grips) to hold out the pin while the brakes 
are bled????  Also, it seems to me that there was a trick with the front 
bleed screws, but I can't remember what it was.  Anyone know for sure about 
that????


Thanks.


Alan Coleman
#246