The cables snap into little U shaped "holes that are on angle brackets that
are attached to long plates that are bolted to the front of the hood
latches. I'd send you some photos but my Camera took a crap, It don't like
the dust around here.
Rick
> I've got a couple of questions on the hood release cables.
>
> 1. How does the hood pull handle mount under the dash? I have 1 hole
> with (the top one) that looks like there may be a nut welded behind it.
> There is a second larger hole at an angle below it. Looks like you can
> reach the bolt to put a nut on the back of the A pillar. If this is the
> case. It looks like the handle will be at about a 45deg angle.
>
> 2. There is a round end that fits into a clamp. Where is this clamp
mounted?
>
> 3. I have a short piece of cable with a sheath on it and 2 rounded ends,
like
> on the end of the hood release pull cable. I think this one goes across
> between the two hood latches. Are the rounded ends in a clamp? If so,
> where are these clamps mounted.
|