*#%**@ :^(
My battery cables to the bat. are clean and tight. There is a little juice
making it through the system but not enough to fire the electric compressor,
the door solenoids, or fire the starter.
My battery charger says the bat is fully charged. What gives?
I was wondering if there is a bad ground some where, that someone could
recommend I check.
I am going back out there to check the solenoid.
Any Suggestions?
TIA
Jim
1191
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/bricklin
|