That's exactly what mine are. I just didn't know the exact terms. Is there
any advantage to the nylon vs brass?
Marvin
In a message dated 2/14/02 7:53:10 PM Pacific Standard Time,
symbiotic@hotmail.com writes:
> >Marvin,
> >
> > What caps and plastic compression rings? Where do they go?
> >
> >John
>
> John,
> In my past life as a mechanic at a plant that used bunches of air fittings
> and solenoids we used both the fittings that had the nipplesin them and
> used
> nuts that had nylon ferrels in them -- the hole in the nut was slightly
> larger than what we use now and the ferrel had a sleeve that went a little
> above the nut and then would slide on the tubing and that would slide over
> the nipple in the fitting. No muss no fuss. In other words, if you looked
> at one of the nuts there would be a sleeve of nylon extending out of the
> hole and the ferrel would be inside. It seems complicated but it's not. Kim
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/bricklin
|