I was saying that the actual rams,(the ones that go from the Bricklin floor
to the door)are the same as the convertible ones.Not the ones that assist in
opening the doors,those little ones are door struts,and I have no idea what
interchanges with those.
Claude
1024/1136
----- Original Message -----
From: Jeff Wood <Cybertec@thegrid.net>
To: CBL302 <cbl302@email.msn.com>
Sent: Sunday, November 12, 2000 11:48 AM
Subject: Question?
> Here you say the cylinders for a mustang top will work. Would these be
the
> long rams, or the gas assists? I have an air door system, but in my car
the
> rams were replaced with these huge air-hogs. I'm under the impression that
> most air conversions are simply removing the hydraulic pump and replacing
it
> with air.
>
> My rams work ok, but I'm thinking that to improve my system I may want to
go
> back to the original rams.
>
> Thanks,
>
> Jeff
> ----- Original Message -----
> From: CBL302 <cbl302@email.msn.com>
> To: <Bricklin@autox.team.net>
> Sent: Tuesday, October 17, 2000 2:53 PM
> Subject: Re: AIR DOORS - finally a leak!
>
>
> > Basically,the orignal hydroelectric door system was nothing but a setup
> for
> > Fords Convertible tops,that bring said you can use the same lines from
any
> > ford mustang convertible(you can also use the cylinders,that lift up the
> > convertible top, from the Mustang convertible they are the same as what
is
> > on the Bricklin.
> >
> > Claude
> > 1136
> > ----- Original Message -----
> > From: David Ebel <david.ebel@visitalk.com>
> > To: Bricklin (E-mail) <bricklin@autox.team.net>
> > Sent: Tuesday, October 17, 2000 4:30 PM
> > Subject: AIR DOORS - finally a leak!
> >
> >
> > >
> > > Yup. My doors are seriously leaking now, and the leak is not easily
> > > found with the old soap and water trick. Is it such a bad idea to
just
> > > replace all the air hoses and connection fittings? It seams like that
> > > wouldn't be very hard, and it would probably solve the problem. I
know
> > you
> > > have all encountered this situation before - so I am open to advice.
If
> I
> > > do that, where would I get that hose stuff? ACE Hardware?
> > >
> > > thanks.Dave
> > >
> > > -----------------------------------------
> > > David Joseph Ebel PCN: 3333-2222-1111
> > > david.ebel@visitalk.com
> > > visitalk.com - Software Developer
> > > Office: (602) 776-2026 | Cell: (602) 315-9585
> > > Owner- Bricklin #841 <www.davidebel.com>
> > >
> >
> >
> >
> >
>
|