>I have a few questions for anybody who may be able to assist me.
>
>I have a 1975 Brick (#2525), and it has lost the power (12V) by the
ignition
>switch. I cant figure out what happened. the car WILL start, but it will
not
>continue to run after the ignition it released to the "RUN" position after
>starting it.....???? There simply is no power when the key is placed in the
>accessory position. ( cranked forward )
>
>Any ideas as to what happened???? I checked all the fuses.
=======
I assume you have a problem at the column mounted switch.
=======
>
>I am also looking for a some parts:
>
>1) The headlight bezels ( both of them )
=======
AFAIK, these should be generic for any 7" sealed beam.
=======
>2) The plastic pieces that go on either side of the center of the council
that
>cover the sides of the stereo and all the "loose" wires.
=======
I have a '75 that I bought new and it didn't come with these, nor have I
seen one with any. Were they added to the later VIN's?
=======
>
>Last question. I want to replace the heater/vent control panel, ( or the
>whole thing ) mine is pretty well shot, what type of car does it come from?
=======
It was used in a number of Ford products, from '70s Pintos to T'birds. I
guess you'll just have to rummage through junkyards, as I doubt they're
still available from dealers.
GM
>
>Michael C.
|