Wow- 37 Bricklin messages- life is good.
In response to John, apparently my door center console switches were
not hooked up properly when I got the car. Only the pink hot wire and
the white "down" wire were connected. Connecting the orange "up" wire
fixed me up. BTW- this is the air door setup-4 solenoids on the board
with the regulator in the middle, which I replaced- it leaked off
pressure above approx. 90 lb..
My insurance co. is Liberty Mutual.
I replaced my master cylinder, along with the calipers and rear wheel
cylinders. The brake master cylinder is EISAE71103 and sold for $70.
All I need to do ( yeah right ), is glue on my new headlight covers
and pass inspection this Saturday. I made new headlight brackets out of
16 ga. stainless and punched 96- .125" holes on .5" centers on the
surface hoping this will adhere better than a smooth surface.
I cannot wait to get this out on the highway, it sounds real good just
idling.
Also, thanks for the many tips concerning ball joint replacement-
Thanks, Jeff Wynn 2157
|