No I did not get a ferrule for plastic tubing. I don't even know
what it is never mind. THe tubing and connectors are used in air neumatic
printing machines. I had never seen them before. They work perfectly.
Unscrew the current connector. Screw in the bayonet connector and press the
tubing onto the bayonet. I have NEVER had one blow off. I've even tried to
take the hose off after and had to cut it off. This works perfectly. AND I
HAVE NO LEAKS.
Paul
At 03:42 PM 2/18/98 -0500, Greg Monfort wrote:
>I assume you did get a ferrule for plastic tubing. I recommend "Swagelok"
>brand, if they're still available. They had a patented design that 'bit' in
>a little better than others.
>
>GM
>-----Original Message-----
>
>The hose is old and rather stiff so my
>>next guess is that it is too hard for the compression fitting to bite into
>>adequately. If I don't hear any better ideas, I will next try replacing the
>>hose.
>>
>>Scott Isensee
>>
>
>
>
>
>
|