Better (louder) Stereo?
Or if u can Drill thru upto the bearing area so u can put a zerk fitting
and pump Grease better into the area? I think a Zerk Fitting is 10-24 thread
pattern.what i mean is drill the bracket/urethane where u can access it easily,
u should only need one hole.Remove the Zerk and put a Plug after pressing grease
into the bearing area,if u don't have too much room for it.
>>>arnold
-----Original Message-----
From: David Ireland [mailto:david@labyrinthsoft.com]
Sent: Monday, October 21, 2002 12:40 PM
To: Bay Area Racers
Subject: RE: Squeaky Urethane?
earplugs. :)
-----Original Message-----
From: owner-ba-autox@autox.team.net
[mailto:owner-ba-autox@autox.team.net]On Behalf Of Johann Schubert
Sent: Monday, October 21, 2002 11:44 AM
To: Bay Area Racers
Subject: Squeaky Urethane?
Anybody have a good solution for stubborn squeaky urethane bushings?
Thanks,
John
--
****************************************************************************
*
* John Schubert; Morgan Hill, California
* http://www.rx7.org/jes, http://www.rx7.org
*
* The opinions contained herein are my own, because nobody else wants
them...
* "Ban low performance drivers, not high performance cars."
****************************************************************************
*
|