At 11:26 PM -0800 1/26/00, Andy McKee wrote:
>story at one specific rpm. Locating that area higher on the rpm range allows
>taller gear ratio choices to maintain equivalent ground speeds than
>a lower rpm
>range engine, thus greater overall acceleration.
May I ask for clarification to my question about Torque = HP @ 5,252
RPM which was explained to be true? Are there cases where Torque and
HP will both be increasing beyond 5,252 RPM? I can see it plotted out
-- but does it happen in the real world?
A yes or no with perhaps an example will suffice as the math, as
evidenced no doubt by my questions, will only add to my confusion. :-)
--Dan
Dan L. Bratten
'79 Trans Am 455/5sp -- CP 37 (Continual Project)
<http://24.240.36.69/CP/>
|