Ball joint tools frequently look and work just as you described. At least
they do for Chrysler products.
As a matter of fact, the Neon stud removal tool is listed by Miller
Specialty Tools as a Ball Joint Tool.
Eric Linnhoff in KC
'98 Dodge Neon R/T (see-dan)
#69 STS
www.geocities.com/eric10mm/KnuckleDragger
----- Original Message -----
> I'm looking for a tool that can press the studs through from the
> outside, without putting undue pressure on anything. I'm thinking
> something like a c-clamp, but with one side forked to go around the stud
> to allow it to be pushed through.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Partial archives at http://www.team.net/archive
|