Hey Tom,
I saw the post but didnt have much to say about it.
That rear section of the diff is sheetmetal, so you would probably
be in for some brazing to seal it back up when you are done.
Might look a bit unsightly.
Jarrid
>
>I posted this question on the SAOCA forum and got no answers. Maybe
>someone on the list can help.
>Has anyone tried cutting an access hole (and installing a matching
>plug/cover) in the top of the back side of a stock differential to
>check/tighten the ring bolts?
>Thank you.
>Tom
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Alpines@autox.team.net
http://autox.team.net/mailman/listinfo/alpines
http://www.team.net/archive
|