B Hi Lauri, B I did exactly what you are talking about. B The welding wasn't
much of a problem. B However, I was not able to use the manifold because of
clearance issues with the steering box. B The manifold was cut and welded to
mount the carbs at the maximum angle allowed but it still wouldn't fit. B I
ended up using a manifold intended for a standard Alpine head and Webers. B I
had to weld up the intake ports a little to match the Holbay head.
tom hill -------------- Original message from ?auri Lehtinen
<lehtinen.lauri@kolumbus.fi>: --------------
> Hi folks,
> has anyone cut and welded an aluminium intake manifold?
> In theory it could be posseble to cut and weld a H120 dual weber manifold
to
> fit series Alpine, but I am quite sure the intake channels do?'t hit if
> there is a part missing. Has anyone tried?
>
> Lauri, Finland
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Alpines@autox.team.net
> http://autox.team.net/mailman/listinfo/alpines
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Alpines@autox.team.net
http://autox.team.net/mailman/listinfo/alpines
http://www.team.net/archive
|