Mark :
If Nissonger reworked it, they should also have the (bottom) correct
gear set to fix it. I would contact them first to correct the problem.
Ron Tebo
Mark J Bradakis wrote:
>So we have this Alpine in the shop, Series V, I think (I'm a Triumph
>guy, what do I know? ) The owner says the speedo reads too low,
>following a car doing 55 mph his reads 42 mph, roughly 75% of
>what it should.
>
>It appears to have the original 3.89 ratio final drive. It takes 4.25
>revolutions of the driveshaft to make the speedo cable complete
>one revolution. The numbers on the Jaeger speedo are 5324/50 1020.
>
>The owner claims that the speedo was redone by Nissonger recently.
>The cable turns freely, no kinks, no binding.
>
>Any ideas why the speedo reads so much lower?
>
>mjb.
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>
>Alpines@autox.team.net
>http://autox.team.net/mailman/listinfo/alpines
>
>http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Alpines@autox.team.net
http://autox.team.net/mailman/listinfo/alpines
http://www.team.net/archive
|