I agree with the rivet recommendation. What is the thickness of the wear
surface? The forces working adversely on the wear surface are rotational
shear, not forces that would lift the wear surface off the flywheel.
Assuming there is sufficient thickness to the wear surface I would consider
shuffle pins to prevent rotation, then rivet it to the flywheel. Any competent
machine shop should be able to do this. Besides, you'll want to magnuflux the
wear surface and dye-penetrant test the flywheel first to insure it's not
coming apart or through the bell housing when you least expect/desire it to do
so, and after the fabrication is complete you'll want to balance the assembly
again.
Heli-coils would work, provided there is enough thickness to the flywheel for
them to get enough interlocking threads. I would instead recommend a
"time-sert" type repair; and a competent machine shop will know the best type
for the job.
Good luck and happy racing!!
Carl Lotus 61 FF, formerly Series 1 Alpine
----- Original Message -----
Subject: Re: [Alpines] Aluminum Flywheel question
Dan since the surface will most likely outwear you, I would use large press
rivets. A machine shop should be able to put them in or you can use the
old
"backyard Billy" method and pound them yourself. Drilling them out would
be
easy for a surface change if needed.
I would not hesitate using the heli-coil method either as the pressure is
lateral on the bolts.
P
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Alpines@autox.team.net
http://autox.team.net/mailman/listinfo/alpines
http://www.team.net/archive
|