Hello folks,
I found in Owners Handbook that there is a hole (gearbox tunnel cover)
around gear shift lever. I put my fingers in at shift lever hole and
indeed, I could feel screws. There are carpets glued into floor so I
tear them loose only if I can work at this hole.
Is it possible to remove the upper part of tranny via this hole? I am
afraid one tiny spring is too weak and allows 3rd and 4th gear to pop
out when driving. I could maybe fix that problem without removing whole
tranny. On the other hand, I am going to put 1725 engine in, so removing
transmission is not so difficult at the same time.
#auri Lehtinen #orenzo Pamfletti
Toimittaja, insinvvri journalist, engineer
Helsinki, Finland
mobile +358 (0)400 851988
|