So I finally got around to having another bout with my trans for my
SerII alpine.
And here's why it's a bout: The front shaft of the transmission will
not slide into the thrust bushing I installed into the flywheel.
It may be that I buggered the bushing but here's what I really think:
The shaft has a slight difference in thickness about an 1/8th of an
inch at the end. that 1/8th inch goes in fine but stops at the fatter
part of the shaft.
Is this difference in thickness normal. Did I screw something up or do
I just need to muscle the shaft in?
Any and all appreciated.
Eric
'62 serII
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|