Thanks to all who have responded. I still have not found a whole driveshaft,
but here is what I now know:
The automaitc driveshaft on the Series IV is the same as the OD driveshaft
The OD driveshaft measures 30 5/8" from yoke to yoke
The standard driveshaft measures 34 1/4" from yoke to yoke
Therefore, I need to remove 3 5/8" (someone check the math) from a standard
driveshaft to make it work with the OD.
Thanks again everyone.
Chris Stephenson
PeopleSoft Implementation and Support
cs@tscg.net
(404) 915-7669
|