We were able to move the body shell for my Tiger with four medium sized guys
manning two 4X4s placed approximately where the axles would go. The 4X4s
were long enough to extend about 2 feet on either side of the car. It was a
little touch and go though and 4 bear sized guys would have been better.
Frank
---- On Wed, 12 Dec 2001, Ian Spencer (ian@sunbeamalpine.org)
wrote:
> Light surface rust will appear after the body has been
> touched by bear hands.
Having bears around the shop is probably a bit hazardous
anyway. ;-)
Seriously though, what's the typical reassembly sequence after
dipping? Mainly curious if the wheels usually go back under
it before paint and body. Seems like moving a freshly painted
body-shell around (on/off trailers between shops, etc) without
wheels and without inflicting dings would be tough for most
hobbiest restorers. Is it not as bad as it sounds?
Regards, Bob Douglas
|