alpines
[Top] [All Lists]

Re: Sheet Metal - Rear Valance

To: mbgardner <mbgardner@core.com>
Subject: Re: Sheet Metal - Rear Valance
From: Ron Tebo <tebomr@cadvision.com>
Date: Sat, 01 Sep 2001 05:57:58 -0600
The address you want is Rob Martel Enterprizes

http://www.bss.ab.ca/rme/

Ron Tebo

mbgardner wrote:
> 
> My SV and me just got bumped from behind.  Some admirer got a little too
> close.  Luckily the car was on empty as fuel start leaking.  I managed to
> get home with minor whiplash since the seats have no headrests after just
> finishing installing the three point harness.  In a way I feel lucky I
> wasn't wearing the belt and harness when it happened. In any event the
> bumper is caved in the center but no damage to the trunk lid other than
> paint scraped off the outer edges.  The rear valance is toast.  Is this
> bolted on or welded?  I recall some discussion on the list about a good
> sheet metal supplier.  I'd be obliged to see his name and contact
> information again.  Thanks

<Prev in Thread] Current Thread [Next in Thread>
  • Re: Sheet Metal - Rear Valance, Ron Tebo <=