Hi all:
there is a very good software program called SpeedCalc which allows one to
input tire circumference, rpm, and rear end ratio to determine mph. One can
also input mph along with tire circumference and rear end ratio to determine
rpm. Very easy to use. I have a copy which I may be able to send along as
an attachment to those who are interested.
Ol' Blue is back on the road! My spare engine is installed and running just
fine. I got my original engine block back from the machine shop today.
Cleaned and cooked the block and bored .30 over, $10/cylinder. I also had
them polish the crank - $10.00. New hardened exhaust inserts are $10 each.
My cost for their work will be under $100 with tax.
from hot south dakota
Paul
-----Original Message-----
From: owner-alpines@autox.team.net
[mailto:owner-alpines@autox.team.net]On Behalf Of Bill Blue
Sent: Wednesday, June 27, 2001 9:50 PM
To: 'Jan Eyerman'; Jay_Laifman@countrywide.com; alpines@autox.team.net
Subject: RE: [Re: Overdrives and rpm]
I got my numbers by going to the Coker tire site and looking up the
"original" tire size. The 600R 13 (MIchelin) came up, along with the
factory spec outside diameter. I then went to the Cooper Tire site (very
easy and informative place to get tire info)and found that the 195 70 13
otside dimeter is only 20 thou different from the original Michelin. I used
23.75" in my calculations.
By the way, I noticed at the Invasion that most Alpines wear 185 70 13, with
175 70 13 a close second. A few had 195's and most Tigers sported 205 60 13
in the rear, with a smaller size in front. Could someone clue me in as to
what is going on here?
Bill
-----Original Message-----
From: owner-alpines@autox.team.net
[mailto:owner-alpines@autox.team.net]On Behalf Of Jan Eyerman
Sent: Wednesday, June 27, 2001 7:48 PM
To: Jay_Laifman@countrywide.com; alpines@autox.team.net
Subject: Re: [Re: Overdrives and rpm]
I am not sure if those numbers are right, I have calculated 3500 RPM for a
'59
Minx with a 4.55:1 rear with 5.60x15 tires. Even with smaller wheels, I
would
assume an Alpine with a 4.22:1 rear would have to do better, and a 3.89:1
rear
MUCH better.
Jan Eyerman
1959 Hillman Minx Series III DeLuxe
1973 Hillman Avenger DL
Jay_Laifman@countrywide.com wrote:
Tom writes:
>With all this talk of Overdrives, ...
>does anybody know how fast the Series
>V engine is approximately turning at
>65 mph?
My speedo is completely accurate, as it was just calibrated, but my tach is
probably off. I do recall others reporting certain RPMS, etc. I do
believe though that before I changed to the OD (and the speedo was not way
off), my tach would read about 4000-4100 at 65. Now, with the OD and the
calibrated speedo, at 65 I'm reading about 3600. I believe others have
reported 3300 rpm at 65. For a long time, I've believed my tach to be
about 250-300 high. So, this makes sense.
That all said, I think someone had and equation for all this, and thus had
the exact numbers, perhaps taking into account some tire size change too.
Jay
|