Mark and gang,
While I wouldnt arbitrarily bore from .020 to .060 (stop at .030 or .040
first),
I would have no problem using those .060 pistons.
You can always have custom pistons made if it suits you.
Jarrid Gross
-----Original Message-----
From: owner-alpines@autox.team.net
[mailto:owner-alpines@autox.team.net]On Behalf Of
SunbeamAlpine64@aol.com
Sent: Thursday, May 03, 2001 7:47 AM
To: alpines@autox.team.net
Subject: Flat top Pistons
I've only managed to find one set of flat top pistons here in the UK and
they're +60th (thanks Tom Hill) - does anyone else know of any that can be
used with standard 1725 rods & how much they cost? I'm reluctant to buy the
+60s the advice seems to be don't go over +40th or am I being too cautious.
After reading the David Vizard book I'm keen to get this project underway.
p.s. I saw the sun today in London!
thanks in advance
Mark
Series IV with tired 1600cc
(and a 1725 stripped and aching to be put back together with some mods)
|