Wow,
Hay, that worked, now we have all the lights working, Thanks, Now
comes Miller, no windscreen time.
Thanks,
Bob Berghult
Series IV, B9405637 LRX 39 (mine)
Series 3 GT, B9203825 LRX 39 (son's)
> -----Original Message-----
> From: Ian Spencer [SMTP:SpenceIC@Healthall.com]
> Sent: Friday, April 06, 2001 11:31 AM
> To: bob.berghult@lmco.com
> Subject: RE: Bad Ground on Headlight?????
>
> Install the frame to car LAST!!! The windshield is an easy process. Put
> the rubber seal around the glass. Lay the glass with seal in place into
> the frame. It should be easy to see how the rest works...just take a small
> screwdriver or something and work the rubber lip around the frame. next
> install stainless trim. Mount frame to body..don't forget rubber trim
> between frame and body. Last peice is stainless trim across bottom od
> windshield frame.
>
> >>> "Berghult, Bob" <bob.berghult@lmco.com> 04/06/01 09:22AM >>>
> Hi Ian,
> We're getting close, after we turned on the lights, we started up
> the engine, it purred like a kitten. You and Jan should be proud. The
> one
> thing left on the car is the windscreen. What's the order of installation
> on that? We put the frame back in, then we put the gasket(seal) around
> the
> glass, then we tried to put it in the frame, that process beat us both up.
> What did we do wrong? Should we use soap? How does the darn thing go in?
> HELP, HELP.
>
> Bob Berghult
> Rick Berghult
> Series IV, B9405637 LRX 39 (mine)
> Series 3 GT, B9203825 LRX 39 (son's)
>
>
>
> > -----Original Message-----
> > From: Ian Spencer [SMTP:SpenceIC@Healthall.com]
> > Sent: Friday, April 06, 2001 11:05 AM
> > To: bob.berghult@lmco.com
> > Subject: Re: Bad Ground on Headlight?????
> >
> > Yes.. this is a classic ground problem. There should be a receiving clip
> > on the inside of the engine compartment next to the hole that the wires
> go
> > through. This clip is where the ground plugs in.
> >
> > >>> "Berghult, Bob" <bob.berghult@lmco.com> 04/06/01 08:56AM >>>
> > Hi List,
> > As we put the finishing touches on the Series 3 GT and turned on the
> > lights, every thing worked, but, the right headlight was real dim. Now
> > this fender has a lot of Bondo and Fiberglas in it. I don't know if
> there
> > is any steel left. For all you electrical weenies out there, should I
> add
> > a
> > wire from the headlight bucket to a good ground on the chassis or would
> a
> > wire from one of the mounting screws to a good chassis ground do?
> (Isn't
> > that the same thing??)
> > Thanks,
> >
> > Bob Berghult
> > Series IV, B9405637 LRX 39 (mine)
> > Series 3 GT, B9203825 LRX 39 (son's)
> >
> > [demime 0.97c removed an attachment of type application/ms-tnef]
[demime 0.97c removed an attachment of type application/ms-tnef]
|