A couple of years ago, Smitty showed me a jar full of bushings he had
had made for that job. Drill the body out, press in the bushings,
install new throttle blade and shaft. I wonder what he would charge for
that?
Russell Hedges
"Witbracht, Ivan L" wrote:
>
> I have a Series 2 with twin Zenith carbs that I rebuilt about ten years ago.
> However now, I have an air leak at the point where the throttle shaft enters
> each of the carb bodies. 1) Since I can't remember, is there a bushing
> there that can be replaced? 2) If not, would this be the type of job a
> normal machine shop could handle? 3) Any other suggestions?
>
> Thanks.
|