I have been thinking about what to do with that same gasket ours did not last
long after putting on the stainless exhaust. Was thinking to make one out of
some copper sheeting.
Jay_Laifman@countrywide.com wrote:
> I have recently notice that there are special high temp "form a gaskets"
> available for exhaust manifolds. I have never used them. But, then, I
> have never had luck with the gasket between the end of the SV exhaust
> manifold and the two down pipes. Is there any reason not to use this
> stuff? Do they harden into cement that can't be taken back off without a
> air chissle? How about on the gaskets between the head and the exhaust
> manifold or headers?
>
> Jay
|