On R&R Drip Rails,
Jay,
Easy to get off. Use good thin putty knives in steel. Start
and inside edge and pry up a little at a time along it's
length until the bottom edge slides past the bottom corner,
then catch it.
. Harder to get back on after painting because the fit is so
tight. After a careful razor blade "skinning" of the new
paint on the top edge and the bottom corner, it snapped right
back on with finger pressure and some palm persuasion. Hook it
on the top edge first, push down, and press the bottom corner
around the edge of the top rail.
BTDT
DAD
--
Steve Laifman < Find out what is most >
B9472289 < important in your life >
< and don't let it get away!>
_/_/_/_/_/_/_/
_/ _/_/_/ _/_/_/ _/
_/ _/ _/ _/ _/ _/ _/_/_/_/
_/ _/ _/ _/ _/ _/ _/
_/_/_/_/_/__/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
_/
_/_/_/
|