I see. I run a stainless six-into-one header with the single pipe back to a
non-stock muffler (I got from Summit) running in-line with the exhaust,
rather than transverse like the stock muffler.
It's be nice if those selling the rear Addco bar included a caveat advising
those who plan to install the bar to also plan on some special attention to
the
rear muffler arrangement.
Cheers,
Dave
On Sun, Aug 31, 2014 at 9:08 AM, Greg Lemon <glemon@neb.rr.com> wrote:
> David, good point about the exhaust/muffler clearance, I don't run a
> stock set up, but your post reminded me that I had clearance problems too,
> I ended up having to pull the pipes up a little and also shimming the sway
> bar mount down off the frame just a little to make it all fit, still tight.
>
> Greg Lemon
_______________________________________________
Archive: http://www.team.net/archive
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
|