make sure the throttle shafts line up as that could create some binding.
I used the original thinner clips between the shafts as they flexed a
little more than the aftermarket ones. Nothing wrong with the kit, just
modifying the linkage may be difficult for some. Doesn't ratco make a
cable that could work???
Disconnect the linkage clamps and see if a good idle can be obtained. if not
then its a carb issue. Connect the linkage and if not idle then look for
binding and make changes to get things to line up and move freely.
> Date: Sun, 3 Feb 2013 19:07:02 -0500
> From: gaf3@charter.net
> To: 6pack@autox.team.net
> Subject: Re: [6pack] 6pack Digest, Vol 5, Issue 19
>
> I have the same TR6 Triple Strombergs.
> The issue is the carbs will not go back to idle.
> I pulled the linkage and re evaluated the modification. No improvement
> All the carbs have been rebuilt with new seals and kits.
> The problem has been the linkage which is minimal at best.
> I use a return spring to bring the carbs back to 800-1000 rpm.
> I like Goods parts but this has not been good revision.
> I am not happy with the tripple Strombergs;.
> Glenn
>
> ----------------------------------------------------------------------
> Message: 1 Date: Fri, 1 Feb 2013 20:46:37 -0600 From: "Dave"
> <dave@ranteer.com> To: "Triumph 6 Pack" <6pack@autox.team.net> Subject:
> [6pack] tr6 Message-ID: <C4A8F1E4682E4064A835B7DFBE099C66@Datsun>
> Content-Type: text/plain; charset="us-ascii" triple carb, few other
> mods, carbs recently rebuilt by a mechanic but I put them back on. car
> idles at 2500; does not want to go below. have the idle screws all the
> way out. thoughts? ------------------------------ Message: 2 Date: Fri,
> 1 Feb 2013 21:21:38 -0600 From: Irv Korey <emanteno@comcast.net> To:
> Dave <dave@ranteer.com> Cc: Triumph 6 Pack <6pack@autox.team.net>
> Subject: Re: [6pack] tr6 Message-ID:
> <CAFWFMyhrifDfJF0Z2RMt2hWkZK0y=Fj6pe+vmVKfH8U194EEgg@mail.gmail.com>
> Content-Type: text/plain; charset="us-ascii" On Fri, Feb 1, 2013 at 8:46
> PM, Dave <dave@ranteer.com> wrote:
> >> triple carb, few other mods, carbs recently rebuilt by a mechanic but I
put
> >> them back on.
> >>
> >> car idles at 2500; does not want to go below. have the idle screws all
the
> >> way out.
> >>
> >> thoughts?
>
> ________________________________________
>
> 6pack@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/6pack/rsh17@msn.com
________________________________________
6pack@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/6pack/mharc@autox.team.net
|