Yeah, there's no access cover for the side of the tranny tunnel
and it is a problem.
I tried to salvage the speedo cover from my original tranny tunnel but
the shape is different for the new molded plastic tunnels. Seems like
someone could manufacture a run or two of these and it would fill
a gap left there by the Big 3. They all sell the molded tranny covers
but no one sells a speedo cable adapter cover that fits the molded
tunnel.....
Dave
'74 Six w/A/OD +TBI
On Tue, Jul 5, 2011 at 5:34 PM, Bruce Simms <brucesimms2003@yahoo.ca> wrote:
> Okay, replacing old dash with sharp looking burl venner one. While I'm in
> there....replace and lube
> speeo cable, tach cable, oil presuure line and all
> the bulbs. What else?
> Outer casing on sppedo cable torn, so out she
> comes. Maybe speedo will be
> steadier.
> Everything apart, so far so good
> except for undoing sppedo cable at OD
> adapter. Can't get enough on it to
> unscrew it. Not enough room.
> The shop manual section for this job says to
> remove right side tunnel carpet and
> take off access cover, great except that
> my 73 is an A type OD conversion, so no
> got one.
> The plastc tunnel cover from
> the RF didn't have that option when I bought it.
>
> So, looks like I need to cut
> one out. Drill a hole and cut out acess panel
> with a sawzall. Shouldn't
> take long. Roger William's book "How to Restore
> TR6" has a picture of
> one on pg 106. I guess I'll follow that unless folks
> have other
> recommendations or measurements I could follow. Guess I'll cover
> the hole
> with sheet metal and self tapping screws.
>
> Thank you,
>
> Bruce Simms
>
> ________________________________________
>
> 6pack@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/6pack/forzion7@gmail.com
________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|