Hello Darrell,
I used a cut down piece of a finishing nail that is a tiny bit narrower than
that barrel instead.
It went in easy and spring pressure keeps a hold on it, been working just
fine.
You might give it a try.
Regards,
Bob
-----Original Message-----
From: 6pack-bounces@autox.team.net [mailto:6pack-bounces@autox.team.net] On
Behalf Of TR250Driver@aol.com
Sent: Monday, January 17, 2011 1:26 PM
To: triumphs@autox.team.net
Cc: 6pack@autox.team.net
Subject: [6pack] TR6 Inside Door Handle Installation
Hey Guys,
I have about an hour in it now with Beverly helping. No success, we just
gave up. Trying to get that little barrel into both holes with the springs
behind the door is impossible!!!!! I have done this before but I think I
always coped out and took the springs out. Then it is just very difficult.
I have the door glass replaced, the panel back on and all I need is the
handles back on.
I hear there is a special tool for this. Anyone know where I can buy one?
Any tips on how to make this job possible? I tried using needle nose vise
grips & needle nose pliers.
Thanks,
Darrell
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/6pack/rpeglow@optonline.net
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|