On Wed, 29 Dec 2010, Sally or Dick Taylor wrote:
> Dave---Muffler shops have slip joints to connect the pipes. These seal
> pretty well, but can be troublesome to disconnect after time. A better
> way is to have the shop weld on flanges to the open ends. These flanges
> are then bolted together, which can be more easily separated when the
> time comes.
As they say in Facebookland:
LIKE
flanges are good. especially if you take things apart from time-to-time.
> Dick
regards,
rml
---------------------------------------------------------------------------
Bob Lang Triumph TR6!! | This space for rent
2010 NER Solo Chair |
Voice:617-253-7438 | Cell: 339-927-4489
---------------------------------------------------------------------------
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|